0
0 Cart (empty)

Brands

New products

All new products
D-Link DGS-1250-52XMP/E Switch 48xG PoE+4x10G SFP+

D-Link DGS-1250-52XMP/E Switch 48xG PoE+4x10G SFP+

$891.88 Tax excluded
The D-Link DGS-1250-52XMP/E Switch 48xG PoE+4x10G SFP+ is a product of the Switches and Access Points section - New State Cabinet Switches.
Condition
New
Brand:
D-Link
Id.
107360
EAN
0790069467905
MPN
DGS-1250-52XMP/E
Available (10 Items)

Brand D-Link
Model DGS-1250-52XMP/E
Hardware Features General
- Hardware version: A1
- Interfaces:
48 x 10/100/1000BASE-T PoE
4 10G SFP+ ports
RJ-45 console port for CLI management
- Port standards:
IEEE 802.3 10BASE-T Ethernet (twisted pair copper)
IEEE 802.3u 100BASE-TX Fast Ethernet (twisted pair copper)
IEEE 802.3u 100BASE-FX 100 Mbps over fiber optic
IEEE 802.3ab 1000BASE-T Gigabit Ethernet (twisted pair copper)
IEEE 802.3z 1000BASE-X 1 Gbps over fiber optics
IEEE 802.3az Low Energy Ethernet (EEE)
IEEE 802.3x Flow Control
IEEE 802.3ae 10 Gigabit Ethernet
IEEE 802.3af/at (PoE models only)
- Network cables:
UTP Cat. 5, Cat. 5e (100m max)
- Duplex mode:
Full/Half-duplex for 10/100 Mbps
Full-duplex for 1000 Mbps
- Multimedia interface exchange: Automatic adjustment of MDI/MDIX on all twisted pair ports
Performance
- Switching capacity: 176 Gbps
- Transmission method: Save and send
- Maximum forwarding speed: 130.95 Mpps
- MAC address table size: 32K
- Static MACC addresses: 256 entries
- Packet buffer: 16 Mbits
- CPU memory: 2G DDR3
- Flash memory: 64MB
PoE
- PoE Standard: IEEE 802.3af/at: IEEE 802.3af/at
- PoE Supported Ports: 24
- PoE Power Budget: 370W
Feeding
- Power input: 100 to 240 V AC
- Consumption:
PoE enabled: 443.6 W
PoE off: 57.2 W
- Standby consumption: 28.4 W
physical
- MTBF: 309,053.10 hours
- Acoustics:
Max 50.8dB(A)
Min: 42.0 dB(A)
- Heat dissipation:
PoE enabled: 1471,415 BTU/hr
PoE Off: 133,331 BTU/hr
- Weight: 3.85kg
- Dimensions: 440 x 430 x 44mm
Software Features L2 Characteristics
- MAC address table
16K tickets
32K entries (DGS-1250-52X/52XMP only)
- IGMP Snooping
IGMP v1/v2/v3 Snooping
Support 256 IGMP groups
Supports at least 64 static multicast addresses
IGMP per VLAN
Support IGMP Snooping Querier
- Loopback detection
- 802.3ad Link Aggregation:
Supports a maximum of 8 groups per device and 8 ports per group
-LLDP
-LLDP-MED
-Jumbo Frame
Up to 12,000 bytes
- Spanning Tree Protocol
802.1D STP
802.1W RSTP
802.1s MSTP
- Flow control
Flow control 802.3x
HOL Blocking Prevention
- Copy of ports
one to one
many to one
Support copy for Tx/Rx/Both
- Multicast filtering
Forward all registered groups
Filter all unregistered groups
- MDI/MDIX configurable
MLD snooping v1/v2 sensitization (256 groups)
VLANs
- 802.1Q
- VLAN group
Max 4094 static VLAN groups
- VID configurable from 1 - 4094
- Asymmetric VLAN
- Auto Voice VLAN
Max 10 user-defined OUIs
Max 8 default OUIs
Quality of Service (QoS)
- 802.1p Quality of Service
- 8 queues per port
- Queue management
Strict
Weighted Round Robin (WRR)
- Bandwidth control
Port-based (in/out, minimum granularity 10/100/1000 at 16 Kbps)
- Based on QoS:
802.1p priority queues
DSCP
MAC address
EtherType
IP adress
protocol type
Cough
IP preference
IPv6 type traffic
TCP/UDP port
L3 Features
- IP interface
Support 4 interfaces
- IPv6 Neighbor Discovery (ND)
Static Routing
124 static IPv4 route entries
- 50 static IPv6 route entries
Access Control List (ACL)
- Max. 50 access lists
- Max. 768 rules shared by IPv4, MAC and IPv6
- Each rule can be associated with only one port
- ACL based on
MAC address
- 802.1p priority mask
- VINE mask
- Source/destination MAC address mask
- EtherType mask
IP adress
- Source/destination IP address mask
- DSCP mask
- Protocol type mask
- TCP/UDP port number mask
IPv6 address
- Source/destination IP address mask
- DSCP mask
- Protocol type mask
- TCP/UDP port number mask
- IPv6 traffic class mask
security features
- Broadcast/Multicast/Unicast Storm Control
-D-Link Safeguard Engine
- Traffic segmentation
-SSH v2
-TLS v.1.2
- Prevention of DoS attacks
- Access control based on 802.1X ports
- Port protection
Supports up to 64 MAC addresses per port
- ARP Spoofing to prevent spoofing
Max 127 entries
- DHCP server detection
- IP-MAC port binding (smart binding)
ARP inspection
- Max. 64 entries
IPv4 inspection
- Max. 127 entries
IPv6 inspection
- Max. 63 entries
DHCP snooping
- Max. 512 entries
AAA
- 802.1X authentication
Support local database/RADIUS
Support port-based access control
Supports EAP, OTP, TLS, TTLS, PEAP
Max 128 entries when using a local database
- RADIUS IPv6 server
- Supports MD5 authentication
OAM
- Diagnosis of cables
- Factory reset
network management
- Web-like GUI
- D-Link Network Assistant
- Console port
- Full Command Line Interface (CLI)1
- Telnet server
- TFTP client
- MDI/MDIX configurable
-SNMP
Support v1/v2c/v3
-SNMP Traps
- Backup/firmware update
-Smart Wizard
- Configuration file upload/download
- BootP/DHCP client
- System log
Max 500 log entries
-SNTP
-ICMP v6
- IPv4/v6 dual stack
- Automatic DHCP configuration
- Time setting
SNTP
-RMONv1
- Trusted Host
- Dual image
- dual configuration
Review date 06-13-2022 by MPM

Reviews (0)

No customer reviews for the moment.